Filter
Top Products
1
Certified to comply with ANSI A112.18.1
M968630 Rev. 1.1
TOWEL RING, ROBE HOOK and TISSUE HOLDER
MOUNTING BRACKET INSTALLATION
GREEN TEA ACCESSORIES
Installation
Instructions
7010.190
7010.210
7010.211
7010.230
Thank you for selecting American-Standard...the benchmark
of fine quality for over 100 years.
To ensure that your installation proceeds smoothly--please
read instructions carefully before you begin.
TOWEL RING
ROBE HOOK
DOUBLE ROBE HOOK
TISSUE HOLDER
Regular Screwdriver
Recommended Tools
Phillips Screwdriver
Drill
10'
Tape Measure
CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR
WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: CLEAN THE PRODUCT WITH SOAPS, ACID,
POLISH, ABRASIVES, HARSH CLEANERS, OR A CLOTH
WITH A COARSE SURFACE.
The TOWEL RING, ROBE HOOK and TISSUE HOLDER work best if secured to a wall stud or cross brace within the wall, using 1-1/2"
long SCREWS (3) not supplioed.
If the TOWEL RING, ROBE HOOK and TISSUE HOLDER are to be installed on a tile or plaster wall the ANCHORS (4) and SCREWS (2)
should be used.
Secure MOUNTING PLATES (1) to wall with SCREWS (2).
Determine desired height and location (optional) for the accessory and mark a center line. If MOUNTING BRACKET (1) is secured to a
stud or cross brace drill small pilot holes for SCREWS (3). (NOTE PROPER POSITION OF MOUNTING BRACKET FOR ACCESSORY
TO BE INSTALLED.}
For installations on drywall or tiled walls, use ANCHORS (4) and SCREWS (2) for securing MOUNTING BRACKETS (1) to wall. Use MOUNTING
BRACKET (1) as a template and mark the mounting holes. Drill three 1/8" diameter holes a minimum of 1-1/4" deep. Insert the three
ANCHORS (4) flush with face of the finished wall.
1-1/2"
4
1
2
DRILL 3 PILOT HOLES FOR
WOOD SCREWS (2) OR
1/8" DIA. HOLES FOR
ANCHORS (4)
CENTER
LINE
3
LEVEL
POSITION OF
MOUNTING BRACKET
FOR TOWEL RING
AND ROBE HOOK
POSITION OF MOUNTING
BRACKET FOR DOUBLE ROBE
HOOK AND TISSUE HOLDER