Filter
Top Products
7
1
Introduction
How to Use this Manual
This manual describes the operation of the Agilent 14761A Harmonic/Flicker Test System (HFTS)
software when used in conjunction with the Agilent 6800-Series AC Power Source/Analyzers. Its
primary function is as a reference manual. If you have a question about a specific screen or how to
perform a certain task, simply turn to the appropriate section of the manual. The manual is organized
according to the procedure that you would follow if you were to run a compliance test. This manual
assumes that you are familiar with the EN 61000-3-2 and EN 61000-3-3 regulations and their
requirements. It also assumes that you are familiar with operating a personal computer in a Microsoft
Windows environment.
The manual is organized as follows:
Chapter 1 provides an overview of the regulations and how compliance testing to these regulations is
implemented with the Agilent 14761A HFTS software.
Chapter 2 describes how to install the software and get it running. It describes some pitfalls to avoid so
that operation of the software will be glitchless and error-free.
Chapter 3 describes what you need to do to before you can run a test. There is certain information that
you need to provide about the Device Under Test as well as setting up the Agilent 6800-Series AC Power
Source/Analyzer.
Chapter 4 explains what happens when the pre-test and the compliance test is run.
Chapter 5 describes how to view the test data both while the test is running and after the test completes.
Chapter 6 describes the software tools available to find and display specific test data.
Chapter 7 explains how to print graphs and test reports.
Appendix A lists the product specifications
Appendix B is a glossary of terms related to the EN 61000-3-2 and EN 61000-3-3 Regulations.
Appendix C is for programmers. It describes the SCPI programming commands that implement the
harmonic/flicker tests.
Appendix D explains the class determination logic of the Agilent 14761A HFTS software, and how this
logic is used to set test limits.