Filter
Top Products
2 - Installation
14
Default Settings
In the Options menu, select Defaults to view the default settings. The following settings are configurable:
ñ The line voltage and frequency that will be applied to the equipment under test.
ñ The quasi-stationary/fluctuating harmonics regulations version that you will be testing to.
Select either EN 61000-3-2 or the older EN 60555 Part 2 regulation.
Press OK to accept the defaults, or Cancel to cancel the changes and exit the dialog box.
Getting Around in the Application
There are two ways to access the various functions of this application:
1. From the drop-down menus at the top of the screen, or
2. From the menu tabs at the bottom of the screen.
The menu tabs at the bottom of the screen are the same as the View menu commands.
Drop-down Menu
The following commands are located in the drop-down menus at the top of the screen.
File
New...
Lets you select a new test
New From Template...
Lets you select a new test but applies an existing set-up template
Open...
Opens an existing test
Save
Saves the presently opened test
Save As...
Saves the present test under a new name
Lock Test File
Sets the attribute of a completed test file to read only
Edit Template..
Lets you edit a template
Save As Template...
Saves only the template information of the presently opened test
Print Pre-test
Lets you print the currently displayed pre-test screen
Print Report...
Lets you print the currently displayed report
Print Graph/Table...
Lets you print the currently displayed graph or table
Printer Setup...
Lets you change the printer setup
Exit
Exits the application